Product Overview
**THIS IS NOT MY DESIGN, I ONLY MADE SLIGHT MODIFICATIONS, ALL CREDIT GOES TO PEMBIE**
Stainless steel trips and 3D printed PLA+ trigger shoe for Glock 17, 19, 19X, 20, 21, 22, 23, 26, 43X, 48. You must disassemble your existing trigger assembly to install. COMES WITH A DURABLE TRIGGER SHOE AND FFT CUT TRIP (2 sizes). Oil your gun for best results, especially the top of the barrel/underside of the slide. WARNING this does NOT have a trigger safety.
***FOR BEST RESULTS PLEASE FOLLOW THE OPTIMAL SETUP BELOW***
OPTIMAL SETUP:
-20lb recoil spring
-3.0lb Ghost Unit or Ghost Edge connector
-4lb striker spring (might get light strikes with hard primers)
-Lighter safety plunger spring
-Oil (barrel/underside of slide/slide rails)
-Light trigger pull when shooting
WARNINGS:
- By purchasing or using this product, you are accepting responsibility and liability for the serviceability of the final installation, as well as any damage or wear that may occur to your firearm.
- Improper installation or use of the FRT may lead to unintentional discharge of the firearm that may lead to injury or even death.
- We recommend installation be performed by a Professional Gunsmith.
- After the FRT has been properly installed, it is imperative that all users seek qualified training on how to use this product.
